Recent content by scottybilt

guys i darn nere blew myd902 up because the rad fan didnt come on and gauge was almost in the Red. I need help wth the two wires in the plug connticion. wich one is 12 volt from battery? iam hard wireing a manual toggle switch. I dont want to burn up somthing in the fan motor!! THANKS for any...

So glad you are feeling better now bud,iam 70 years old ,had a heart attac and bladder cancer to deal with,getting old is not fun ,iam ok now but what a life changing time in my life.....BTW bcboom please keep us updated. Scotty

did you check lift pump ? if not unplug short tube from lift pump and roll engine over to se if its working right. my 2011 900xt had hard starting issues and i installed a electric fuel pump and that ended all starting issues. Cheers, Scotty

not sure bud but i would try takeing off fuel tank fillcap off and see what that does,could be clog in vent in cap

Dusty,take the fuelcap off and try ,cheers,Scotty

yes

aurthuritis, are you shur about the 3800 rpm? i just checked my WSM and it says 3200 rpm, for a d902. hate to see bozi22 rod go thru side of block!! Cheers Scotty

OK guys,can we get back to head gasket replacement and stop the BS.......this is a great thread and alot of us that have d902 really helps,...btw banjo did you get your machine up and running?

I endedup buying one on ebay, if you buy a new shaft and install you find it will flop around lik a fish outa water because the male splines on front and rear are warn and will takeout the splines on new shaft....kubota really droped the ball on this, the splined nipple should have a clamp to...

Banjo,where did you order your parts from? I have a 2011 900xt thats loosing anti freeze and may need a head gasket,Kubota wants over a 100.00 dollars! you can get them from amazon for 40.00 dollars! anybody out there tryed aftermarket head gasket with good results? If so who?

(On my machine? Are you referring to the tube that is the belcrank?) no.....yes, also if you look at that lever yours is clocked at about 10:30 his is at almost 12:00, that would easly create the slack in cable,

guys, if you look close at the pics you ca see what looks like that lever that holds cable end has broke and rewelded wrong by the tube.

Guys,if you think udt2 is expensive wait till you price the HST and suction filters for rtv900....62.00 for two filters from kubota dealer near me!!!!! WHAT A BUNCH OF BS!!

2011 900xt 1400 hr.

BiffNH,I to have a hard time reading the transmission level on the stick. i was going to paint it flat black but after thinking about it i dident want the paint to fall off into the trany. so i thought ide try a small bottle of gun bluing.first i used steelwool and breakleen and cleaned it real...