Recent content by ssefick

Ok, I'll take a look. Honestly any thing could be stuck in there. Happy dog training! I'm trying to teach Sweep his inside flanks. He helped gather my little pasture today.

New rtv x2. Oil levels good. All Kubota recommended fluids. ~70hrs. Brake, engine, hydraulic reservoir, and vht all show full on the various dipsticks etc. It squeaks under load only. That is going down hills, or decelerating quickly. Still under warranty, and will go in at 100 hours for...

Sounds like the rear brakes are 'squeaking'. That isn't making sense to me as they are bathed in hydraulic fluid from the transmission, right? Anything I should be looking at/for? The machine is 5 months old ~70 hours. I use the machine to work, but don't abuse it. Any thoughts? Thanks!

Look like the Kubota factory tires to me. I have around 300 miles in them. They're pretty good.

The tires are good. I work the machine in my little sheep farm in a flood plane. I hardly ever use 4wd. But I have it and a winch if I need it.

Dave the shifting does loosen up a little through breakin. Take a look at your fluids and make sure they are filled. Mine were a little low from the factory. Enjoy yours as well. Mine is more important than my car! 20 hours a month.

Thanks Doc! The sides flip down and come off to convert to a flat bed. Please let me know if this picture doesn't clear things up, and I can take another one. This is at the front of the bed. That handle unlatches the side. The side flips down and 2 pins are removed to take the side off. The...

Hello All: I have a pro Konvert bed. It is great. It is about 1/2in out of plumb where the tail gate meets on one side. Is this normal? Should I be concerned while it is still under warranty I can get it fixed. The bed is rolled a little under the tail gate. Parking brake rubber is also...

Great thank you! 2 seconds is doing the trick most of the time.

Good evening. Brand new owner '25 rtv x2. Great little machine. I know these can be a touch 'tractory' with regards to shifting a little hard. Any help would be great. Tips, tricks, etc. I just can't figure out the pattern. Range selector: Hard shift procedure: mash break to engage pressure...