Recent content by Tennslim

  1. T

    Bit of a neighbor problem

    Read thru this set of posts. Undoubtedly the rain, obstruction and land drainage plus the "neighbor" are real problems. Water flow, in my area, that obstructs or floods county roads is dealt with by the local COuty judge. He has the Road Scrapers, Dozers and other heavy movers to aid local...
  2. T

    Modify ROPS

    My LM2800 has a foldable ROPS which I NEVER fold down. That safety device has saved my bacon from low hanging limbs many times. Catch a tough limb and the whole tractor simply stops. Semper FI
  3. T

    Thinning out the woods

    Good Day... I work a similar Tree Farm, 13 acres of Oaks, Hickory, cedars, Pines and such. One item. I fertilize the "sick" trees in the Fall and early Spring. 10 10 10 usualy. Also, a good trunk dose of Malathion mixed with H20, does in the Web Worms at the base of the tree. I worry about...
  4. T

    Hello i am new here and a Kubota owner

    Kubota tractor type? Use of ? Experiences with (so far) end Semper FI
  5. T

    Overheating problem

    I vote for an air lock. Drain and refil, run, check the hose for leaks. end Semper FI
  6. T

    M4700 3 Point position control

    Kubota tractor stiffness Storage of Kubota tractors sometimes means the HST Hydraulic fluid is contaminated. The HST LM2800 Filters also need changing at 50 hours and 200 hours. BE CAREFUL of fluid. The stuff is greasy and runs everywhere. I use Kubota UDT and thier filters. I use normal...
  7. T

    How many hours on your Kubota?

    I have a K LM 2400. Use it to haul a Rhino SE 5 Bush hog, and carry rocks.... Some 185 hours, bought in 2007, from a dealer in Arkansas. This setup is used on a Arkansas rock, tree acerage. So far the K is about the best tractor I have used. My older tractor was a Allis Chalmers, C model. You...
  8. T

    M4700 3 Point position control

    The position control probably has become "Stiff" due to grease/oil/dirt contamination. The control is partial mechanical, with joint connections. I had the same problem with the PTO Engage control. A long set of mechanical connections. WD 40, soak, re apply and work the lever alot. bt The 3...
Top