Search results

So the backhoe has been acting up after we blew a hose and replaced It. First the swing wouldn’t go left so I pulled the relief valve and cleaned put it back in and it worked for a minute then stopped working again. Tried again and then the slick quit working. Pulled valves cleaned put back and...

could it be a loose skid plate or exhaust cover?

Those wont work with the full factory cab modles

The sound goes away even at low speeds. If you gently press go pedal get it rolling then mash on it for a second and let up it quiets down. Do that a few times and it stays quiet for 10 seconds or so even if you stop and go

All fluids changed about 100 hrs or so ago. All Kubota filters and udt 2. Definitely seems like something with transmission. Maybe a charge pressure issue??? Or maybe it’s just the k connect and pto for the snowblower.

Stored in heated garage so cold is not the issue. It is loud and vibrates until I’m up to speed and let off throttle then if I’m back on throttle it’s still quiet. If I don’t let off the throttle after I start moving it will stay loud and vibrate at all speeds and throttle settings until I let...

So when you start to move the 2016 1100c is louder and vibrates more until you get up to speed and let off the throttle a little bit. Then it smooths out and gets qouiter. Kinda like when the clutches shift on a sled or wheeler. Fluids are full. Is this normal any ideas why it does this?

Not sure all I can think of is that little spring clip got squished some how or the axle was not completely seated when we bought it used?

Axle popped out of front diff all back together

2016 x1100c front wheels are not engaging in 4wd. Had chains on back with blower but couldn’t steer for crap so I moved the chains up front and noticed that the back tires are spinning but the front tires are doing nothing. Jacked all 4 wheels off ground and put in 4wd and the front tires move...

I’m looking for pictures of the k connect plow. I have the blower and want to fab up a plow to go onto the k connect. If anyone has pictures of the k connect plow side mounting brackets it would be a great help to my project. I’m looking at using a 6’ straight blade plow off a Jeep for my...

Ok so I found out why it was hesitating. Apparently these newer rtvs use the hydraulic system in conjunction with the transmission fluid. I did a full service on this machine when I got it, drained and refilled hyd tank cycled the hydros and rechecked the fluid before changing the transmission...

Valves or values were changed? What are the new numbers?

So in theory if I can climb steep hills and get 24-26 mph the high pressure valve should be ok and I should be looking at the charge valve correct?

Yes I have the manual. We’re all the pressures raised (charge and high pressure)

No one has an ideas why the hst is hesitating on my 2016 x1100c??? like i said push the pedal down (doesnt matter if its a 1/4" or all the way down) it takes a second for the trans to move the wheels? Is there a relief valve that controls this?? Charge pressure??? Any pics where this is...

pretty sure there is a poppet under that plug with an oring sealing it thus no oil getting in there to keep from rusting. the plug is just a stop restricting the movement of the poppet

Pranut, really need something like you made for the earlier models that go up both sides of the a-arm to protect the front and rear side of the boots. I just received the metal Kubota ones and installed them today. The front ones are smaller than the plastic ones and don’t offer much protection...

kubotausa.com has all the parts diagrams online free

Mine does not