I’m trying to replace my driveshaft u joints front and rear on my 04 rtv900 and cannot find the part number anywhere. All I’m seeing that Kubota offers is a new driveshaft for the front, and a new yoke for the rear. Does anybody know if Kubota makes just the ujoints I’m after, or an aftermarket part number that would work for me?
2004 Kubota RTV900 Driveshaft U Joints
- Thread starter Jak85
- Start date
aurthuritis
Well-known member
Search boardercollie posts. I'll bet she lists the part numbers some time back
Thank you Aurthuritis. I did the rears on the 05 I had ,and used some aftermarkets ujoints that member Mark S sibole recommemded. That was in the first ujoints post I did, and I had to alter them a bit. I'd never ever do that again though. I had to use a hydraulic press to get the old ones apart. The number 392 comes to mind but like I said I'd never do that again. The second plus time I did them on my 2011 RTV , I used Kubota joints and believe I had pictures of the parts all laid out on the work table posted. best I remember. I think they may make the whole assembly now for the replacement . It includes the boots and its all together- just waiting to be installed. Just make sure you phase them as described by a poster in the thread " Rear ujoints needed again" They may vibrate if you don't. Good Luck . I sold my RTV in April of 2019 and now have a diesel Roxor . https://www.nettractortalk.com/foru...joints-needed-again.13788/page-13#post-116366
EDIT Just realized this is for the driveshaft and not the rear ujoints. . No I bought a new front driveshaft for the 05. Check your carrier bearing while you're under there .
EDIT Just realized this is for the driveshaft and not the rear ujoints. . No I bought a new front driveshaft for the 05. Check your carrier bearing while you're under there .
Last edited: