Kubota Light Install

[Tom B]

Has anyone installed the Kubota front work lights (V5282) on a new RTV1100C yet? I'm not sure if it's pre-wired or what is involved.

Thanks

 

[Rogerwh0]

Mine was prewired. There is a plug under each plate on the roof. The switch plugged directly into the harness under the dash cluster, one relay in the fuse panel and they fired right up. Takes about 15 min to complete.

 

[Tom B]

Mine was prewired. There is a plug under each plate on the roof. The switch plugged directly into the harness under the dash cluster, one relay in the fuse panel and they fired right up. Takes about 15 min to complete.

Thanks for the information.

 

[OrangeBuggy]

I have the Kubota work lights front and rear, single rear light as there is no factory wiring for two. Also installed a radio in the over head console. It is pre wired for lights and radio. A nice bonus if you're adding a radio is the antenna is per installed from Kubota. I'm happy with Kubota's head lights and the work lights. I was surprise that there is no low beam though.