Parts for Curtis plow hydraulic lift conversion

[ccmdvl1960]

what size cylinders did you use for the right and left angle?

The plow was equipped with the OEM angle cylinders from Curtis... I did not add them.

 

[powerwagon]

ok thanks i have just the manual angle and was thinking about adding cylinders also but need to know the size.

 

[ccmdvl1960]

ok thanks i have just the manual angle and was thinking about adding cylinders also but need to know the size.

Kubota #V4207 Hydraulic Angle Kit for V4208 Blade(RTV900/1100)

Included in kit- 17" Hose(2), 23" Hose, 26" Hose, 1500 PSI Coss Overrelief valve block, 90 degree swivial elbows (6), valve block bracket, stroke S.A. Hydraulic Cylinder(2), 60" heat resistant hose sleeve, 126" HP Hose, Coupler weather caps, couplers, nipples, hardware, installation instructions.

www.messicks.com

Here is the OEM angling kit - if you call Messicks, they may be able to give you exact specs on the cylinders.

 

[Jimsequipmentshed]

I thought I'd give a five year update. The RTV now has about 1495 hrs on it. The hydraulic setup as outlined above has worked flawlessly - no changes or repairs needed. The only fixing that has needed to be done is on the plow itself - some welds needed to be redone. Future changes might including altering the plow assembly to allow for higher lift height and moving the switch to change between lift/angle to the dump lever and use a momentary contact switch (button) instead.

I'm getting ready to do this mod myself, fun fact, the parts you specked out in 2015 are still available. thats impressive.....