V4210 complete cabs only $1200


Super Site Supporter
SUPER Site Supporter
Just curious, how did you prep the panels and how did you apply the coating?

They look really good, BTW.


I pulled the door panels off. I left the roof on but removed the trim & LED lights.
Then the following steps:
  1. Traditional wash
  2. Rough up all surfaces with a scotch brite pad
  3. Wipe down all surfaces with MEK
  4. Apply two coats of ML
I also added SS washers to the lower mounting screws on the door panels. I had a few cracks in the panels and once you pull them off it is clear why there were cracks present in those locations.