Latest activity

My knowledge of hydro transmissions is very, very limited. If it's something you can tear down, identify any/all issues and rebuild it's...

I have a Mahindra 3525 2wd tractor and the handle to engage PTO broke the other day. I had handle welded back on but had to handle off...

FYI - I just found my muffler rattling badly and upon investigation I found the two bolts that hold the muffler bracket to the...

Sorry. No ideas. Following Good luck getting to the bottom of this. Changing fluids seems like a good idea

This is embarrassing, but I'm posting it anyway. Turns out I didn't have an oil pressure problem. In fact, after adding an actual oil...

Have done everything that owner’s manual suggested including putting in a new thermostat. It runs like it should. A very low hour...

Hi there, I have been looking to see if this might be too much candy for a nickel. 2008 Kubota 900 UTV, Motor in good condition...

Thanks Fedup that’s what I’m thinking too but having trouble finding a wiring diagram to find all grounds I’ll just start at one end a...

Just guessing here, but "running bad" and gauges acting up at the same time. I have no specifics for what the problem might be, but...

Having never seen (or worked on) a 2032 I have no personal experience to share. However, the symptoms you describe are indeed common to...

Hi all, I have a 2032R Series 1. I went to use it today and it cranked and ran fine. Picked up a few small limbs with the grapple and...

No bolt in the end. End is closed. Triangle end on outside of filter housing. 3 bolts hold hoising in place. There is, however, a...

Thanks Fedup that’s what I’m thinking too but having trouble finding a wiring diagram to find all grounds I’ll just start at one end a...

Just guessing here, but "running bad" and gauges acting up at the same time. I have no specifics for what the problem might be, but...