Which RTV?It isn't removable.. Sorry to tell you but it is part of the frame.
And a breaker bar, cheater bar and your 1/2" drive metric sockets. I just went out to the RTV again. Front ROPS bolts are 17mm. Assuming the rear are the same.take some penetrating fluid and you should be good to go.
Also, I'd take an adjustable crescent wrench along with a set of end wrenches or sockets. you will need an assortment to take off those braces pieces across the top that connects the front and rear rops.- those bolts/nuts are smaller but not sure of the size. You will probably need to take off the side's plastic or remove at least the top couple of allen type bolts, so you can get a wrench on the back side of the rops mounting bolts . If it has a top, that will need another sized wrench. collieAnd a breaker bar, cheater bar and your 1/2" drive metric sockets. I just went out to the RTV again. Front ROPS bolts are 17mm. Assuming the rear are the same.
I put a 17mm wrench on one of them. It wouldn't budge so I figure you're going to need the breaker bar and maybe a cheater bar.
Doh! I forgot about the top ones. I have a ceiling so I never see them.
Wondering if you disconnected the 4 points where it attaches to the RTV itself if you can just lift it off in one piece. Does it have a windshield, roof or anything else or is it the bare ROPS?
I'm a little late to the party but why not just rent an appropriate trailer. They're $50-55/day around here and several places rent them including a few really nice aluminum units. Bob