Search results

Sorry, I wasn't able to figure that out.

LOL my only frame of reference was the parts page off of the sidekick.

I too have the same knob on my shifter. Yours looks backwards to me...... I also used this grip off a bx tractor for my door opening latches: K2971-42782. when passengers ask "how do I get out of here ? I say push up on the orange knob.

For what its worth there is a company in MN that rebuilds these. They are $3845 with a $1k core charge. https://stoens.com/inventory/tuff-torq-hydrostatic-transmission-k7731-14040/

The drivers side door on my X1100 has become increasingly difficult to open from the inside. So today I decided to see what the problem was. While I didn't see any thing obviously wrong with the mechanism I did notice some surface rust at the bottom of the door by the weep holes. Additionally...

When rebuilding my kubota X1100 all the suspension grease fitting were dryer than a pop corn fart. Upon disassembly i could'nt find any indication that they had ever been greased. After replacing all the bushings and bolts I decided to make a maintenance chart. I found in the owners manual...

looks great!

I have just the lower portion, aka the skid plate. It puts the hitch receiver in a more useable position.

These mirrors are from a major truck accessory company and are all metal. I don't remember the name of the company but soon after installing, I saw the same mirrors at a truck stop. The flat metal piece is what makes them work on the Kubota x1100. The $93 per mirror price is from Messicks web...

my steering wheel comes off very easily, so I removed the upper and lower dash. Taking the steering wheel off is initially difficult, but once off I coat the shaft with never seize and subsequent removals are a breeze. I am thinking that you could probably do it by just removing the lower...

These are excellent if you don't have the Kubota mirrors. https://www.ebay.com/itm/154727166406 plus, the Kubota mirrors are $180 plus $50 for the mod, whereas these are $150 for the set.

these mirrors> https://www.ebay.com/itm/154727166406

thanks, It looks like I could get AS1 windshield for a 1120 or 1140 but not a 1100.

I just received a reply from Kubota which answers my question. Thank you for contacting Kubota Customer Satisfaction department. The current RTV-X1100C front windshield glass has an AS2 rating. You may view further information at...

Believe it or not but it is a federal requirement for vehicles that have a top speed of no more than 25mph. The requirement is for vehicles to be driven on streets with a speed limit of 30mph or less. The requirements are in Title 49 and cover Low Speed Vehicles. I think they intended this...

So I finally found the time to install the gear selector light and the dome light. I ran my dome grounding wire the long way which required me to completely remove the interior. I also tried to use the logic module listed above, however I believe my module is bad. I am waiting on technical...

I am currently trying to get low speed vehicle license plates for my Kubota RTV-X-1100 and I think I might have run into a snag. One of the requirements is to have a AS-1 or AS-4 windshield. My early serial number X1100 has an AS-2 windshield. AS-2 is the only thing that might disqualify my...

You could use a relay, that way you can use the factory switch. I put a light bar on my RTV900 and it came with a switch and a relay.

Using a bigger fuse is never a good idea unless you upgrade the wiring as well. I would guess that your insurance company will deny a claim if the bigger fuse caused a wiring fire.

factory wiring is good for 180 watts.