BX2200 No power to Stop Solenoid? or Safety Switches Wont start

9

90lxtc

New member
Tractor had a Locked up Stop Solenoid and had to be shut off by hand on the Injector Pump. Replaced the SS. But No Power to SS....Did it take out a Relay?

So far i have Checked all the fuses. I see that the Solenoid looked to have its own fuse which was good. all fuses are good except the headlight fuse which blows as soon as i put a 15amp in it.

I dont think this it is related as the solenoid has its own fuse.??

I have Also Checked all the Safety Switches (PTO,N,Seat switch)ETC they all showed contanuity when Pressed. and none when De-pressed. However there is No current to any of these switches at all.?

Under the dash i see 2 Relays and what looks like a Voltage regulator. Is one a Safety Interlock Module? Anyone have a Elec.Diagram? or a suggestion?

The one i suspect to be a Interlock module has 4 Wires..a Red,Black,Yellow,White...
 
I'm sorry 901 but I don't know about this. It seems I remember a similar topic on another model of equipment on this forum though-can't remember how it was listed but- it has been this year. It must be a naked wire touching the frame making that light short out and blow the fuse? Is your key switch o.k.? Good Luck. Bordercollie
 
i assume everything is ok with tthe key switch the tractor turn over like it should....just have lost power in the safety circuit some where.........
 
Electrical issues like this can sure be hard to track down. Wish I had some useful advice to offer but I don't, so I'll wish you luck and request that you please follow up with the solution.
 
You must log in or register to reply here.
Top