quincy
Member
Finally, I got some free time to do some more to my transport box project. I got the sheet metal folded in a fold press so all I had to do was weld on the side plates. the 'bucket' is made out of 3mm mild steel. The sub frame is made of 10mm X 60mm flat bar. Did some work on the sub frame this evening. Heres a few photos of the progress.
Next step is to do some more drilling and get the subframe squared up and all welded up.
![box4Small.jpg](http://i168.photobucket.com/albums/u194/Blagadain/box4Small.jpg)
![box2Small.jpg](http://i168.photobucket.com/albums/u194/Blagadain/box2Small.jpg)
![box1Small.jpg](http://i168.photobucket.com/albums/u194/Blagadain/box1Small.jpg)
![box5Small.jpg](http://i168.photobucket.com/albums/u194/Blagadain/box5Small.jpg)
![box3Small.jpg](http://i168.photobucket.com/albums/u194/Blagadain/box3Small.jpg)
Next step is to do some more drilling and get the subframe squared up and all welded up.