need some pictures if anyone has them

P

Peanut

Well-known member
can anyone with a camera post some pictures of the rear end of a rtv with whatever haydraulics there is back there that would stop a bumper from being put on?i was at the dealers and i was lookin at one and unless that bed comes way up i should be able to put a bumper on it.
 
I suspect your going to have trouble there. The bed does lower alot when you dump it. You be better off trying to build somthing off the bed itself. To give you an idea, you can crush the tail gate on the reciever if you have a ball on there and raise the bed with the tail gate down. We've had more than one customer do it. </P>


</P>
 
yea we ran into the ball on the reciever problem on the rhino my buddy has . he has one of them raised hitches.
 
ok do this for me under the rtv there is a beam that the bed sits on the frame with i think the measurements are 29-1/4" inside to inside take a straight edge and run it down the length of it sticking it out past the bed and lower the tailgate i need to see if the tail gate is flush with that beam when it is lowered.if not can you get me the measurement of the offset with a picture??
 
i need to know if the beam is flush with the tail gate when it down like in the picture put the straight edge on the beam and run it out like the picture.</P>


</P>


</P>


1005181ys9.jpg
</P>
 
You must log in or register to reply here.
Top