Hi All.
I just purchased a used RTV that I want to fix up. It was not taken care of well at all so I know I have lots to do but I want get the basics working first. I don't know anything about these machines so I really need help The engine works well but the problem is it just wont move when put into gear. symptoms are...
-Axles barely spin when in gear and so slow that if I grab ahold of it with my hand it will stop.
-Axles don't increase speed very much when accelerated
-Hydraulic fill tanks forms air bubbles after idle for a few minutes
What I've tried...
-Released all break linkages to make sure nothing is sticking
-Made sure Axles move by hand when machine is off and in neutral
-Replaced all oils and filters for both transmission and HST with proper Kubota materials
-Made sure oil levels are correct
-Went through every Hydraulic hose inlet and outlet looking for leaks and tightening clamps (Also the dump bed lifts no problem)
Could really use some help Fellas. Thanks
I just purchased a used RTV that I want to fix up. It was not taken care of well at all so I know I have lots to do but I want get the basics working first. I don't know anything about these machines so I really need help The engine works well but the problem is it just wont move when put into gear. symptoms are...
-Axles barely spin when in gear and so slow that if I grab ahold of it with my hand it will stop.
-Axles don't increase speed very much when accelerated
-Hydraulic fill tanks forms air bubbles after idle for a few minutes
What I've tried...
-Released all break linkages to make sure nothing is sticking
-Made sure Axles move by hand when machine is off and in neutral
-Replaced all oils and filters for both transmission and HST with proper Kubota materials
-Made sure oil levels are correct
-Went through every Hydraulic hose inlet and outlet looking for leaks and tightening clamps (Also the dump bed lifts no problem)
Could really use some help Fellas. Thanks